- Home
- Gifts & Dog
- Personalized Equestrian Products
- Henri de Rivel Stress Free Halter with Fancy Contrast Stitching
Henri de Rivel Stress Free Halter with Fancy Contrast Stitching
Rambo Blanket Trade-In
Thank you for your trade-in!
Code CM18RAMBO2 has been applied. Discount on eligible products will be applied in your cart.
Attention: Nichole Andrews or Ellie Monteith
400 Broadway
Methuen, MA 01844
52 Ash St
West Newbury, MA 01985
1) Adjust the crownpiece, which will impact the placement of the noseband, the looseness of the throatlatch, and the angle of the cheek pieces against your horse's face. The crownpiece should fit over the horse's poll, close to the back of the horse's ears, but not press into them. Some halters have buckles on both sides of the crownpiece, and some have only one buckle on the left side. In the case of two buckles, try to use symmetrical holes for the crownpiece setting.
2) Check the noseband portion of the halter. It should sit about halfway between the horse's eyes and nostrils, lying under the horse's cheekbones so that the hardware joining the nose piece, chin strap and cheek piece does not press into the horse's cheek bone.
The noseband must be adjusted snugly enough that the horse cannot get a foot or another object caught in it, but loosely enough that he can open his mouth, chew and breathe freely. Use two to three fingers' width between the noseband and your horse's face as a guideline. Some nosebands do not have buckles for adjustment. If this is the case of your halter, take extra care to be sure that you can obtain the optimum position of the noseband by raising or lowering the crownpiece with buckle, and that the noseband isn't too loose or too tight.
If the cheek pieces are too long or the crownpiece is adjusted too loosely, the noseband will sit too low on the horse's muzzle. In this case, it may impair the horse's breathing or in extreme cases, slip over the horse's nose.
3) Check the throatlatch, which should rest under the head where the neck meets the jowls. You should be able to fit three to four fingers into the throatlatch area to be sure that he can breathe and swallow, but this spacing will not enable your horse to get a foot caught in that strap if he lowers his head.
4) Check the cheek pieces. Ideally, they should sit parallel to the cheek bones. If the throatlatch is too short or too long, or the crownpiece is not adjusted correctly, then the cheek pieces will not be able to run parallel to the cheek bones.
Properly fitted halter-the horse can open his mouth and chew, and the straps are positioned in comfortable locations. The halter is not so loose that when being handled, buckles or rings could slip into the horse's eyes.
Poorly fitted halter-the horse could get a foot or other object caught in the loose straps. The halter will slip if the horse acts up while being handled with this halter.
Tip: Because leather can stretch slightly with time and conditioning, check the fit of your leather halter periodically to be sure it hasn't become too loose.
The most traditional and economical method of cleaning involves glycerin soap, a small bucket and a sponge or cloth. Barely moisten the sponge with warm water. Unfasten buckles so that you can clean the creases in the leather.
After washing, and when the leather feels smooth, rub a nearly dry sponge or rag against the glycerin soap bar. Apply a thin layer of glycerin soap (no suds during this step) to your leather to seal its pores and make it soft, but not sticky.
Newer methods of cleaning your halter involve convenient and easy-to-use tack cleaning and conditioning products. One-step leather cleaners also condition your leather as you wipe away grime. Two-step cleaners usually advise following cleansing with a conditioner that will soften and protect the leather.
If your horse's halter has a name plate, shine it up with a soft rag and a metal polish, making sure not to get the polish onto the leather.
Here's some facts to help you decide which type of halter best meets your needs.
Leather
- Classically attractive in a range of leathers from economical to premium.
- Preferred by many for ability to break and free a horse before serious injury occurs if the halter catches on an object.
- Parts of leather halters, once broken, can be replaced or repaired.
- Can have padding and contours for horse comfort; fancy stitching or other embellishments for added style.
- Can punch holes if needed for the perfect fit.
- Can be fitted with a monogrammed halter plate for a custom look.
- Easily cleaned with tack cleaner; last for years with proper conditioning.
- Preferred for turnout by many for the ability of the halter to break and free a horse.
- Colorful nylon or cotton-blend webbing is paired with a leather crownpiece, tab or fuse designed to break if the halter becomes entangled with an object.
- Replacement parts are inexpensive and easy to find, so the halter can be put back into service quickly.
- Can have an engraved halter tag attached for identification.
- Web parts can be cleaned with soapy water and gentle scrubbing with a soft brush.
- Colorful nylon webbing is durable.
- Not considered ideal for turnout because if a horse were to become entangled, the webbing does not break, which places an entangled horse in danger of severe injury.
- Can be cleaned by soaking in soapy water and scrubbing with a soft brush.
- Durable rolled poly or cotton-blend rope construction.
- Intended for ground work and horse handling only; not suitable for use in shipping, cross-tying or turnout.
- Require correct tying to secure on horse.
- Designed for transport.
- May be made of either leather or nylon with a breakaway tab and is encased with soft sheepskin fleece to protect the delicate skin of a horse's face.
- Sheepskin helps wick away moisture to reduce sweating/discomfort under straps.
- May be made of leather or nylon.
- Intended for use with supervision during grooming only; can easily slip off or become caught on an object.
- Intentionally lacks throatlatch and jaw piece to allow for easy cleaning of the jowl areas.
Horse halters come in a range of sizes: foal, miniature horse, small pony, large pony, cob, horse, oversize and draft. Halters are moderately adjustable within each size, and higher end halters allow the noseband, throatlatch and crownpiece to be adjusted independently.
You should measure your horse’s head before you go halter shopping so you can purchase the best-fitting halter available.
Noseband: Place one end of the tape measure at the midway point between your horse’s cheekbone and his nostrils. Stretch the tape measure across the nose to the corresponding point on the other side of your horse’s head. Record the measurement for your horse’s noseband area.
Chin portion of noseband: Starting at the same point between the cheek and the nostril, stretch the tape measure underneath the horse’s head to get the measurement for the bottom portion of the noseband. Record the measurement.
Crown: Place the end of your tape measure directly below your horse's cheek bone on the side of his face. Stretch the tape measure around the horse’s head to the corresponding location on the other side of his face. Record the measurement for the crownpiece of your halter.
Throatlatch: Place the end of your measuring tape several inches behind the horse’s eye near the top of his throat area. Measure underneath the throat to the corresponding area on the other side of the face. Record the measurement for the throatlatch area.
Note: Sizing varies between manufacturers, and not all manufacturers offer halters in all sizes.
100% Satisfaction Guarantee
The Easiest and Best Guarantee in The Business
Shop with 100% confidence at Dressage Extensions. If something doesn’t fit you or your horse, return your original purchase within a year, and we’ll make it right with a refund, exchange or replacement.
Our experience as riders and horse owners ourselves is that in most situations a year’s time is fair enough to evaluate proper fit and function. PLUS: For manufacturer’s defects, we’ll extend the manufacturer’s warranty to a maximum of 24 months, regardless of their individual policies. (AND: Manufacturer warranties longer than 24 months will be honored and supported by us as well up to the length of those warranties).
Exceptions: Safety items such as helmets and protective vests may only be returned within 30 days, with their original tags intact. Saddles and riding boots may be returned within the one year period, but are subject to a prorated refund based on usage. Used saddles may be returned for 30 days only. For everyone’s protection, treats and vet meds which have been opened are not returnable, and returned blankets must clean and free of debris.
To protect all customers and ensure that every return or exchange is handled fairly, we may require a receipt or decline a return in these situations:
• Item was not purchased directly from Dressage Extensions. (It was purchased at a used tack sale or from a retailer or online seller other than Dressage Extensions.)
• Item is missing a label or has been defaced.
• No receipt and no valid identification in our stores.
• Item is wet, dirty or contaminated, or until it has been cleaned. (For health and safety reasons, we cannot accept returns on used, defective or poorly fitting blankets if they are UNWASHED.)
• Item has been lost, stolen, damaged, or misused.
• On rare occasions, based on the nature of prior transactions.
• Supplements have been opened or used.
• Multiple returns of the same item.
• Personalized items may not be returned unless defective.
Security Guarantee
Dressage Extensions understands your concerns regarding online security. We share in your concerns and therefore work hard with experts in the field to maintain a highly secure ordering environment. Along with our comment to security, we offer you a Secure Order Guarantee - this gives you 100% protection for your credit card transactions on DressageExtensions.com.
Our Secure Order Guarantee means that you will never have to pay any money related to unauthorized charges to your credit card account, as long as those charges are a direct result from a transaction on DressageExtensions.com.
How it works: If you experience credit card fraud, the Fair Credit Act specifies that your credit card company can hold you liable for no more than $50.00 in fraudulent charges to your account. Our Secure Order Guarantee will reimburse you for any amount up to $50.00 billed to you by your credit card company for unauthorized charges to your account, if those charges result from an order you placed with DressageExtensions.com. For this protection you must promptly notify your credit card company of fraudulent charges and follow their procedures as outlined in your credit card agreement.
With the Henri de Rivel Stress Free Halter with Fancy Contrast Stitching, you’ll love the traditional detail and your horse will love the extra comfort. It is ideal for hauling to shows and giving your horse ultimate comfort for a stress-free experience. The contoured crownpiece cuts around the ears to allow for complete freedom of ear movement.Leather piping and contrast stitching add a unique twist on classic styling. Stainless steel hardware.
Imported.
Manufacturer Restricted Price Product: Count on Dressage Extensions for the best quality, value and price possible. However, some of our manufacturers restrict advertised selling prices and prevent us from advertising discounts. For other items, some manufacturers allow us to offer and advertise a discount on a limited basis. Therefore, some products are not eligible for discounts.
Henri de Rivel Stress Free Halter with Fancy Contrast Stitching
| Size | NOSEBAND | CROWN PIECE END - TO - END | CHEEK |
|---|---|---|---|
| Pony | 10.5" | 23" | 5.2" |
| Cob | 11.5" | 24" | 6.2" |
| Full | 12.5" | 25" | 7.2" |
| Oversized | 13.5" | 26" | 8.2" |